Textile rubber hose connector installation instructions - Oilfield Drilling Equipment Supply & Solutions
Thursday, 23 March 2017 01:10

Textile rubber hose connector installation instructions

1, can be flexible synthetic rubber joints in the installation, is strictly prohibited super limit installation.
2,1.0Mpa above the ground horizontal, floating, vertical installation of rubber joints, pipe ends should be fixed support or fixed trailer, to prevent the pull or damage facilities.
3, fixed support or fixed force, must be greater than the axial force of work, otherwise, should be installed anti-pull off device.
4, can be installed flexibly synthetic Textile Rubber Hose  joints of the corresponding flange, rubber joints should be used and the corresponding standard small diameter flange, to prevent the flange D2, do size is too narrow, there sealing surface leakage.
5, the installation of flexible rubber joints flange bolts, to be symmetrical step by step pressure to tighten, to prevent the pressure when the local leakage or damage can be flexible synthetic rubber joints sealing surface.
6,1.0Mpa above working pressure horizontal, floating, vertical installation of rubber joints, the installation of bolts to have a spring pad to prevent the work of the bolt loose, resulting in local leakage, water seepage.
7, vertical installation or flexible synthetic rubber joints, there should be a fixed bracket, can not be flexible rubber joints by the pressure.

Read 1443 times