High-pressure wire wound hose There are several kinds of wire-wound hose of the wire-type hose to be pre-determined.For wire winding hose, if the winding wire is not scheduled for processing, cut off the hose on the hose, wrapped in the hose The wire is loosened under elastic action and is affected by the use of the wire. After the winding wire is preformed, the winding hose will not loosen the thread. The wound wire is intended to be of the type and type. This process is to wire the wire preform and winding in the same machine on the continuous completion of the winding before the wire through the winding machine on the special device (pre-tube and sliding sleeve), the wire bent into a certain diameter And the helix of the helix angle, and then wound on the tube. (2) The machine is intended to use a special type of pre-set device for winding wire preformed in the wire into the wire before the first wire in accordance with the required diameter And the winding pitch is bent in a spiral shape for use in molding. The main control parameters of the wound wire are the diameter and pitch